Tappan TGF326WGTG Owner's Manual

Contents

Avoid Service ChecklistBefore you call for service, review this list. It may save you time and expense. The list includes common occurrencesthatare not the result of defective workmanship or materials in this appliance.OCCURRENCERange is not level.POSSIBLE CAUSE/SOLUTIONPoor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjustleveling legs at base of range untit the rack is level. When range is level, cooktop mayappear out of alignment if countertop is not level.Weak, unstable floor. Be sure floor is Jevel and can adequately support range. Contacta carpenter to correct sagging or sloping floor.Kitchen cabinet misalignment may make range appear to be unleveL Be sure cabinetsare square and have sufficient room for range clearance.Cannot move appliance easily. Appliance Cabinets not square or are built in too tight. Contact a cabinet maker to correct themust be accessible for service, problem.Contact builder or installer to make appliance accessible.Carpeting interferes with range. Provide sufficient space so range can be lifted overcarpet.Gas line is hard-plumbed. Have a flexible A.G.AJC,G.A, approved metal applianceconnector installed.Surface burners do not light. Surface Control knob has not been completely turned to LITE. Push in and turn theSurface Control knob to LITE until burner ignites and then turn control knob to desiredflame size.Burner ports are clogged. Clean burners. See 'To Clean the Contoured Well Areas,Burner Cap Assembly, Trim Ring (some models), Burner Pan (some models) and BurnerBaseMunder General Cleaning. With the burner off, clean ports with a small-gaugewire or needle.Range power cord is disconnected from outlet (Electric Ignition Models only). Be surecord is securely plugged into the outlet.Electrical power outage (electric ignition models only). Burners can be lit manually. SeeSetting Surface Controls in this Owner's Guide.Surface burner flame burns half way Burnerports are clogged. With the burner off. clean ports by using a small-gauge wirearound, or needle.Moisture is present after cleaning. Lightly fan the flame and allow burner to operateuntil flame is full. Dry the burners thoroughly following instructions in the GeneralCleaning section.Surface burner flame is orange. Dust particles in main line. Allow the burner to operate a few minutes until flame turnsblue.In coastal areas, a slightly orange flame is unavoidable due to salt air.Oven does not operate. Be sure the electronic oven controls are set correctly for the desired function. SeeSetting Oven Controls in this Owner's Guide or Entire Appliance Does Not Operate(see below).Be sure regulator gas valve is "ON". See installation instructions,14

/ 16

Related manuals for Tappan TGF326WGSB