83. Basic SetupMethods to Connect the Receiver:1. Conventional Receiver: connect it tothe CH1/SBUS and CH2 Channel in thegimbal main controller.2. FUTABA SUBS or SBUS-2: connect it toCH1/SBUS channel in the gimbal1. Receiver Unconnected: set gimbalmode in Default Mode of assistant software.2. Receiver Connected: set gimbal modein MODE channel of the receiver.FPV Mode: The direction of the gimbal anddirections (roll, tilt and pan) of themulti-rotor are theInit Angle stands for the initial angle of eachdirection after the gimbal has been poweredup. For instance, if you want the tilt directionof the camera is on -45 degree, you shouldenter -45 on the corresponding box.Angle Range of Roll: -25°~25°Angle Range of Tilt: -120°~15°Angle Range of Pan: -125°~125°Please press “ENTER” button aftermodifying the parameters.It relates to the response speed of the gimbal.When it becomes too small, the stabilitydeteriorates. When it turns too large,self-oscillation occurs.Methods to adjust: if vibration occurs,please decrease the parameters until itdisappears.Input Range: 0~200Please press “ENTER” button aftermodifying the parameters.Attention: it has been adjusted to anThe maximum rotation speed the gimbal can reach.When pushing sticks to the maximum but therotation speed is lower, you could increase thevalue of Max Rotation Speed to enhance therotation speed;When pushing sticks gradually but the rotationspeed is too fast, you could decrease the valueto slow down the speed.Max Rotation Speed Range of ROLL: 0~200(degree/sec)Max Rotation Speed Range of TILT: 0~200(degree/sec)Max Rotation Speed Range of PAN: 0~200(degree/sec)Angle Range of Rotation on each Directionof the GimbalIf the gimbal rotates to or over the extremevalue, it would stop rotating until the valuegoes within the range.The Extreme Range of Roll: -25°~25°The Extreme Range of Tilt: -120°~15The Extreme Range of Pan: -125°~125°Please press “ENTER” button aftASSEMBLY SECTION 组装说明书T4-3dTA R O T AV I AT I O N T E C H N O L O G Y C O. , LT D塔 罗 航 空 科 技 有 限 公 司