Tascam DA-60MKII Quick Tips

Also see for DA-60MKII: Owner's manual

47) Hold SHIFT and press MENU s or t until you arrive at screen display "9P-id",press DATA (current device will blink)8) Rotate the DATA DIAL to select the device that best suits your controller and pressSET9) Hold SHIFT and press MENU s or t until you arrive at screen display "SPEEd",press DATA (current status will blink)10) Rotate the DATA DIAL to select the speed that best suits your environment (9x or150x normal play speed upon receiving a fast wind command) and press SET11) Hold SHIFT and press MENU s or t until you arrive at screen display "JoG-Ed",press DATA (current status will blink)12) Rotate DATA DIAL to "on" and press SETPLAYBACK TIME CODE SOURCE1) Hold SHIFT and press MENU s or t until you arrive at screen display "-tc- cLoSE"(if display reads "oPEn", proceed to step 3)2) Press DATA ("cLoSE" will blink), rotate DATA DIAL to "oPEn" - press SET3) Hold SHIFT and press MENU s or t until you arrive at screen display "21 PbtcAuto" ("tc" or "AbS" may already be assigned in place of "Auto")4) Press DATA ("Auto" will blink)5) Rotate DATA DIAL to make selection (Auto, AbS, or tc), then press SETNote: "Auto" is the default condition where ABS time is displayed if no SMPTE code isdetected."AbS" or "tc" may be selected for viewing Absolute Time or SMPTE TimeCode.PROGRAM NUMBER DURING RECORDING1) Press MENU s or t until "P-000" (or some other number) appears to the right ofthe counter display2) Press DATA3) Using either the DATA DIAL or the RESET key, enter "000" and press SET4) Hold SHIFT and press SET - a second number "000" will appear to the rightNote: With AUTO ID enabled, the DA-60 MK II will now automatically enter programnumbers with each new Start ID beginning with "1" while in ASSEMBLE MODE.PROGRAM NUMBER LOCATE1) Press MENU s or t until "P-000" (or some other number) appears to the right ofthe counter display2) Press DATA3) Rotate the DATA DIAL and select the desired program number4) Press SET, then LOC 1PROGRAM NUMBER / RENUMBER1) Select EDIT SUB MODE2) Press ID SELECT until "RENUMBER" is displayed3) Press EXE - tape will rewind and program number "1" will be written at the first StartID the system detects