TASCAM DM-24 Version 2.1 Release Notes 1New features in DM-24 version 2.1Buss assignmentBusses 1-8 can now be assigned to the stereo buss onthe ASSIGN page, the MODULE page and also using theASSIGN section key.Bear in mind that like EFFECT 1-2, DIGITAL IN 1-2 andASSN RETURNS 1-4, these signals enter the stereo bussafter (post) the Master Comp Insert Matrix.The result of this is that if you are compressing thestereo buss, these signals assigned to the stereo bussare not affected by the compressor.However, if the ASSIGNABLE sends and returns areused as stereo buss INSERTS, these inserts will affectthe signals sent to the stereo buss. Any analog insertsused on the stereo buss will also affect these signals.1 To assign these signals directly to the stereobuss, use POD 4 to move the cursor to ST inthe upper right of the ASSIGN page.2 Then use the SEL key of the buss, or the cur-sor keys or the dial to highlight the item youwish to assign and press the ENTER key.This assignment can also be made in the bussMODULE page.To assign busses 1-8 to the stereo buss using theSTEREO key in assign section:1 Select the busses 1-8 using the SEL keys.2 Then press the STEREO key in the assign sec-tion. Busses 1-8 are assigned to the stereobuss directly (this can be confirmed on theMODULE page).Buss signals assigned to the stereo buss fol-low the Balance Level CENTER: 0dB setting on theOPTION-PREFERENCES page.9101449300