Taylor-Dunn B0-254-48 Operation, T Roubleshooting And Replacement Parts Manual

Also see for B0-254-48: Operation, t roubleshooting and replacement parts manual Service replacement parts

Contents

Taylor-Dunn B0-254-48 Operation, T Roubleshooting And Replacement Parts Manual Manual pdf 59 page image

Maintenance, Service, and RepairSteering Page 7INSPECT ROD ENDSNOTE: A set of ball joints and/or rod ends will wear at the same rate. If aball joint and or rod end is worn out, then all should be replaced asa set.6. Visually inspect each rod end for any signs of play between the ball and the nylon or brassbushing in the housing.7. If any play is evident, then the rod end is worn outand should be replaced. Refer to section Replacethe Ball Joints, Tie Rods, and Drag Link forinformation regarding replacing ball joints.8. Reconnect the main positive and negative cablesat the batteries.9. Remove the blocks from behind the wheels.10. Release the parking brake and test drive the vehicle.1. Make sure the key-switch is in the “OFF” position, then remove thekey.2. Place the forward-reverse switch in the center “OFF” position.3. Set the park brake.4. Place blocks under the rear wheels to prevent vehicle movement.5. Disconnect the main positive and negative cables at the batteries.Do not drive the vehicle while the steering wheel or front wheels aretied in position. Driving the vehicle while the steering wheel or frontwheels tied in position may cause loss of control of the vehicle resultingin severe bodily injury and/or property damage.Typical rod end. Studded rod end shown, yourvehicle may be equipped with spherical rodends that do not have a stud.< Stud