Recording OperationCheck DVR File SystemPress ‘OK’ button to check if your USB device is ready and compatible for DVR functions. If the USBdevice is formatted and compatible with the unit, it will display a ‘SUCCESS’ message, if the device isnot compatible, it will display ‘FAIL’.NOTE:Failure to identify the File System may be due to insufficient memory space in the flash drive, or dueto a faulty USB cable connecting the unit to the flash drive. Try a USB device with a larger capacity,or another USB cable. Another possibility, as stated before is that the USB device may run on adifferent program that is not compatible with the unit.USB DiskIf a compatible USB drive is attached, ‘PASS’ will be displayed.If the USB device is found to be faulty or incompatible with the unit, ‘FAIL’ will be displayed (pleaserefer to note above).If no device is attached, the option will appear grey.FormatThe USB Storage device will need to be formatted before being used for Recording functions, toensure the USB device connected is been format in FAT32 file system, and that there is sufficientstorage space available for recording programs.Once ‘FORMAT’ is selected, the following prompt will appear as shown in the figure:Time Shift SizeAfter the USB storage device is formatted into FAT32 file system, Time Shift cannotbe altered. During 'DVR File System Check' the display will show that the whole storage device spacewill be used for Time Shift recording, but Scheduled & Manual Recording will still take priority on space.SpeedDisplays the speed of the attached USB device.FAT32NOTE:1- After formatting into “FAT32” file system, youwill still be able to store and share other mediafiles on the same USB storage device.2- Storage devices formatted in “High Speed FS”system can only be used to record video on thisTV and cannot store other media files.Choose the file system type:‘FAT32’ is best for High Speed USB storagedevice“High Speed FS” is best for Low Speed USBstorage devices.RecordingOperationMaintenanceand Service29