Teagle C12 Quick Start Manual

Also see for Tomahawk C12: Instruction book Instruction book / parts list

Teagle C12 Quick Start Manual Manual pdf 1 page image

C12 Quick Start Guide page 1Output capacity: Up to 11t/hrTractor HP: Minimum 160—200Material output: 13-125mmC12 QUICK START GUIDECONNECTING THE C12ONTO THE TRACTORConnect all of the following fittings:• Pick up hitch• PTO• Brakes• Hydraulic hoses• Electrics, both the junction boxand the light socketsFITTINGTHE CONTROL BOXA special 4.5mm core, 6 metre twin core cable with 15 amp bladetype fuse is supplied with the machine. The end with two eyeletsmust be fitted to the battery of the tractor with the cable routedin a suitable position without causing damage to the lead duringoperation. If the connector provided on the supply lead is not tobe used, it is essential that the 15 amp fuse is retained to preventdamage resulting from current overload.SPECIFICATIONSCONVEYOR BELTCLEARANCEWhen the conveyor is at the lowestheight (2.5m), the belt should just clearthe headguard. When the conveyor isat the highest height (4.2m), the beltshould just clear the tubular beam.Keep the belt as slack as possible. Do notadjust unless it is absolutely necessary.Belt tension can be adjusted at the top andthe base of the conveyor.Images of belt tension (highest/lowest tension)UNFOLDINGTHE CONVEYORDo not run the PTO until theconveyor belt is straight &lowered.The minimum discharge heightof the conveyor belt is 2.5metresand the maximum is 4.2metres.C12 Flow rate: 65 lpm with an automatic oil coolerElectronic needed: 2 x 3 pin 12V sockets (1 x cable supplied)Oil fittings needed: 2 x double acting valves1OVERVIEW: COMPLETELY READ THE C12 QUICK START GUIDE DOCUMENTBEFORE COMMENCING OPERATION INSTALLATION2 34SEE THE MANUAL FORMORE INFORMATIONON PAIRING THEDEVICES.Tubular beamHeadguardCONTROL BOXCONNECTIONThe control box is supplied with a suctioncup attachment. This should be fittedin the cab in a suitable position that isconvenient to the operator on a smooth,clean dust free surface.The control box requires a 12v supplyand is shipped with 3 pin plug asstandard. A cigarette lighter to 3 pinsocket cable is supplied and can be usedfor just the control box.Once the junction box is plugged in, plugthe control box in & wait for the blueflashing light to became solid blue whichindicates bluetooth is paired.5

/ 2

Related manuals for Teagle Tomahawk C12