Terex Z4525XCF-101 Operator's Manual

Also see for Genie Z-45 XC: Operator's manual supplement Operator's manual supplement Service and repair manual Operator's manual

Operator's Manual First Edition • Second PrintingInspections44 Z ® -45 XC ™ Part No. 1301594GTTest the Oscillating Axle71 Drive the right steer tire up onto a 6 in/15 cmblock or curb.Result: The three remaining tires should stayin firm contact with the ground.72 Drive the left steer tire up onto a 6 in/15 cmblock or curb.Result: The three remaining tires should stayin firm contact with the ground.73 Drive both steer tires up onto a 6 in/15 cmblock or curb.Result: The non-steer tires should stay in firmcontact with the ground.Test Auxiliary Controls74 Shut the engine off.75 Pull out the red Emergency Stop button to theon position.76 Press down the foot switch.77 Simultaneously hold the auxiliary power switchon and activate each function control handle ortoggle switch.Note: To conserve battery power, test eachfunction through a partial cycle.Result: All boom and steer functions shouldoperate. Drive functions should not operatewith auxiliary power.Test Aircraft Protection Package(if equipped)Note: Two people may be required to perform thistest.78 Extend the primary boom approximately1 ft/30 cm.79 Move the yellow bumper at the bottom of theplatform 4 inches/10 cm in any direction.80 Activate each function control handle or toggleswitch.Result: No boom and steer functions shouldoperate.81 Move and hold the aircraftprotection override switch.82 Activate each function control handle or toggleswitch.Result: All boom and steer functions shouldoperate.