T+A A 1560 User Manual

T+A A 1560 User Manual Manual pdf 29 page image

29Loudspeaker and signal cablesLoudspeaker cables and signal cables (inter-connects)have a significant influence on the overall reproductionquality of your sound system, and their importanceshould not be under-estimated. For this reason recommends the use of high-quality cables andconnectors.Our accessory range includes a series of excellentcables and connectors whose properties are carefullymatched to our speakers and electronic units, and whichharmonise outstandingly well with them.For difficult and cramped situations the  range alsoincludes special-length cables and special-purposeconnectors (e. g. right-angled versions) which can beused to solve almost any problem concerningconnections and system location.Mains cables and mains filtersThe mains power supply provides the energy which yoursound system equipment needs, but it also tends to carryinterference from remote devices such as radio andcomputer systems.Our accessory range includes the specially shielded'POWER FOUR' mains cable, ready-to-use 'POWERLINE' mains cable with integrated shell-type filters andthe 'POWER BAR' mains filter distribution board whichprevent electro-magnetic interference from entering yourHi-Fi system. The reproduction quality of our systemscan often be further improved by using these items.If you have any questions regarding cabling please referto your specialist  dealer who will gladly give youcomprehensive expert advice without obligation. Wewould also be happy to send you our comprehensiveinformation pack on this subject.Mechanical de-couplingThe quality and characteristics of the base on which yourhigh-quality Hi-Fi equipment stands define the limits ofsound quality which can be achieved. The base surfaceshould be as heavy, rigid, hard and level as possible.This CD-Drawer is supplied with the new  dampingcones. This feet feature internal damping qualities whicheffectively de-couple the unit from the base surface.Note:If the base surface is uneven you can screw the standardfeet in or out to set the unit exactly level.All units must be adjusted so that they are exactlyhorizontal in all directions. Check that all feet make solidcontact with the base surface, i.e. that there is absolutelyno tendency for the unit to wobble.