ULTIMATE SPEED IAN 74798 Operation And Safety Notes

Also see for ULG 3.8 A1 BATTERY CHARGER: Operation and safety notes Operation and safety notes Operation and safety notes Operation and safety notes Operation and safety notes

Contents

ULTIMATE SPEED IAN 74798 Operation And Safety Notes Manual pdf 9 page image

9GB/IE/CYnance in the operating instuctions of the vehicle!Otherwise personal injury and / or damage tothe device could occur.Unplug the charger from the mains supply whennot being used! This also benefits the environment.Consider how much electricity is consumed,even in standby mode.Remain alert at all times and always watch whatyou are doing. Always proceed with cautionand do not use the battery charger if you can-not concentrate or feel unwell.Q Product featuresThis appliance has been designed for charging avariety of SlA batteries (sealed lead acid batteries),as mainly used in cars, motorbikes and several othervehicles. They may be of types e.g. WET (with liquidelectrolyte), GEl (with mit gel-type electolyte) or AGM(absorbed glass mat) batteries. A special design ofthe appliance (also named „three-phase-chargingstrategy“) enables the recharging of the batttery toalmost 100 % of its original capacity. Connectingthe battery for a long period to the battery chargeris also a good way of ensuring that your battery iskept in optimum condition.Q OperationBefore you carry out any workon the battery charger always pull the mainsplug out of the mains socket.DAnGer OF eLeCTrICShOCk! DAnGer OF DAMAGe TOPrOPerTy! DAnGer OF InJUry! Ensurethat you do not strike electrical cables, gas orwater pipes when you are drilling into the wall.If necessary, check the wall using a suitabledetector before you drill.You may find it convenient to attach the batterycharger on to a board or a wall. Screw the twoscrews through the mounting holes 12 into theboard or wall.Q ConnectionBefore starting the charging or dischargingprocedure on a permanently installed batteryin a vehicle, first disconnect the minus pole con-necting cable (black) of the vehicle from theminus pole of the battery. The minus pole of thebattery is usually connected to the car body.Then disconect the plus pole connecting cable(red) of the vehicle from the plus pole of thebattery.First attach the „+“ quick-release clamp (red) 15of the battery charger to the „+“ terminal of thebattery (see Fig. C).Attach the „–“ quick-release clamp (black) 16of the battery charger to the „–“ terminal ofthe battery (see Fig. C).Connect the mains lead 11 of the batterycharger to an electrical power outlet socket.Q DisconnectingDisconnect the appliance from the power supply.Detach the „–“ quick-release clamp (black) 16from the „–“ terminal of the battery.Detach the „+“ quick-release clamp (red) 15from the „+“ terminal of the battery.Reconnect the plus pole connecting cable ofthe vehicle to the plus pole of the battery.Reconnect the minus pole connecting cable ofthe vehicle to the minus pole of the battery.Q Select charging modeYou can select different charging modes for chargingdifferent batteries at different ambient temperatures.In comparison with conventional battery chargingstations, this appliance has a special function forreusing an empty battery or rechargeable battery.You can recharge an empty battery / rechargeablebattery. Safe charging is ensured by means of aprotection function against incorrect connection andshort circuiting. Due to the installed electronics, thecharging station does not begin operation directlyafter connecting the battery, but only starts after acharging mode has been selected.Safety / Operation