ULTIMATE SPEED UPBS 12000 A1 Operation And Safety Notes

Also see for UPBS 12000 A1: Operation and safety notes Operation and safety notes Operation and safety notes

Contents

ULTIMATE SPEED UPBS 12000 A1 Operation And Safety Notes Manual pdf 12 page image

GB/IE/NI12Set up/ FAQs / Troubleshooting / Cleaning / StoragePlease note: You cannot use this option ifthe power bank is being charged.Caution Only use the 12V/8A cigarettelighter adapter supplied. There is a risk ofshort circuit if third-party adapters are used.• Switching on the lights When switching on the lights, hold downthe power button 4 for 3 seconds. Press the power button 4 again to switchon strobe mode. Press the power button 4 again to switchon the SOS signal. Press the power button 4 again to switchoff the light.CAUTION! Do not look directly at theLED lights as this can damage your eyes.Note: It is not possible to turn on the lightwhile the power pack is charging.• FAQsQ: How can I switch the device off?A: The device automatically switches off after20 seconds of non-use.Q: How long does it take to fullycharge a mobile phone with thedevice?A: With a battery power of 2500mAh:1A (2–3 hours) / 2A (1–2 hours)Q: How often can a vehicle be star-ted with a fully loaded device?A: approx. 20 times (engine capacity ≤ 2.0 l)Q: How long does the device’s bat-tery last?A: 3–6 months. However, we recommendcharging the battery every 1–2 months.• Troubleshooting = Problem = Cause = Solution The jump start aid is not fullycharged, although all 4 indicatorlights 5 are permanently lit. It is 60% charged after a long period outof use or in storage. Disconnect the power supply adaptor 12or USB power cable 7 and reconnect.The correct number of LEDs are glowing. There is no response to pressingthe power button 4 . The jump start aid’s low voltage protec-tion is activated. Connect the USB power cable 7 to thepower supply adaptor (5V / 1A) 12 .• CleaningYou must not splash thedevice with water or place it inwater. There is a risk of injury due toelectric shock if moisture enters thedevice. Do not use cleaners or solvents. Thesecould damage the equipment beyond re-pair. Keep the casing of the device clean. Use a damp cloth or brush to clean.• Storage Keep the device in a dry location and outof the reach of children. To keep the device and its accessoriessafe, use the enclosed storage bag 16.