ULTIMATE SPEED UPK 10 A1 Operation And Safety Notes

Contents

GB / IE / NI 13Switching on/off: Switching the device on: move the on/offswitch for the power bank with compressor 8 tothe ‘On’ position� Switching the compressor on: move the on/off switch for the compressor 2 to ‘I’� When the right filling pressure has beenachieved, switch the device off: move the on/offswitch for the compressor 2 to ‘0’� Move the on/off switch for the power bankwith compressor 8 to the ‘Off’ position�Disconnecting the connecting valve: Connection without a valve adapter 13 :Open the clamp lever 12 on the connectingvalve 15 by pressing the clamp lever 12 awayfrom the air hose 14 and then pull this off thevalve on the inflatable item� Connecting valve 15 with valve adapter13 : Pull the valve adapter off the connectingvalve on the inflatable item� Open the clamplever 12 on the connecting valve 15 by pressingthe clamp lever 12 away from the air hose 14and then removing the valve adapter�Please note: When disconnecting the connect-ing valve 15 , air can escape from the valve onthe inflatable item� Ensure that you remove theconnecting valve 15 as quickly as possible�The pressure gauge is not trade-approved�Accordingly, after pumping up inflatable itemswhere the wrong pressure could be dangerous(e�g� vehicle tyres), always check the pressure ata service point with a trade-approved device�Tips for useThe device is not intended for continuous oper-ation� The device was designed to create airpressure – not an air flow�Please do not use the device for more than7 minutes at a time on items with a large vol-ume, to avoid overheating and damage to thedevice� Then let the device cool down for atleast 15 minutes� We recommend first fillinga large-volume item with air, followed by thenusing this device to generate the target pressure�If you need a higher pressure than 3 bar fora vehicle tyre, do not use the device for over3 minutes at a time without stopping� Then let thedevice cool down for at least 15 minutes�Air pressure testingConnect the connecting valve 15 (see ‘Using theintegrated compressor’)�Read off the air pressure on the pressure gaugedisplay 3 �Disconnect the connecting valve 15 again (see‘Using the integrated compressor’)�Please note: The pressure gauge is nottrade-approved�Safety fuseIf the device becomes overloaded or malfunc-tions, the safety fuse triggers to protect thedevice�Never install a fuse rated for ahigher trip current� Otherwisethere is a risk of fire!• Switching on the lights To switch on the lights 1 , press and holdthe on/off button on the power bank 4 for3 seconds� Press and hold the power button 4 againfor 3 seconds to turn the lights off again�CAUTION! Do not look directly intothe lights 1 as this can damage youreyes�Please note: It is not possible to turn on thelights while the power bank with compressor 6is charging�• Using the jumpstart featureCheck the charge level of the power bank withcompressor 6 � Check that at least 3 indicatorlights 5 are illuminated�Connect the jumper cable 11 to the vehiclejumpstart outlet 7 �Connect the red crocodile clip to the positiveterminal on the car battery�Using the device