10. Assembly of Row Spacer Kits.ASSEMBLY OF ROW SPACER KITS. - 21SLES-2-3045-003NOTE: When gluing the (2-1410-005) CPVC pipe connectors, it is necessary to use good quality“multi-purpose” cement.When you need to install panels over an obstruction larger than 6’ wide, or if the obstruction is less than 1’ from a panelheader, you’ll need a row spacer kit to circumvent the obstruction.1.2.3.4.Connect (4) of the (2-1410-005) pipe connectors to the headers of the collectors to be connected with a (2-1410-004)plastic panel clamp using the same procedures outlined in the section on connecting solar collectors together onpage 12.Cut two lengths of 1-½” CPVC pipe long enough to cement the (2-1410-005) pipe connectors on each collector toeach other.Cement the PVC pipe to the pipe connectors as shown in Fig. 10.1.If the distance between the collectors is over 4’, a 2” pipe clamp should be used on both pipes to prevent sagging.Fig. 10.12-1410-0042-1410-0042-1410-0052-1410-0051 ½” CPVCPipeINSTALLATION MANUAL eco-SPARK™ SOLAR POOL HEATER©2015 UMA Solar