UNITED OFFICE UAV 190 A1 Operating Instructions Manual

Also see for UAV 190 A1: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Contents

UNITED OFFICE UAV 190 A1 Operating Instructions Manual Manual pdf 7 page image

- 4 -• Place the Strip Cut Shredder attachment ontoa suitable container:First place the broad end of the appliance on theedge of the container. Then pull the telescopearm 4 out sufficiently to ensure that this alsosits securely on the edge of the container.• Insert the plug into a mains power socket.OperationYou can shred up to 6 sheets (80g/m2 paper)at the same time.Attention:Remove all staples and paper clips before feedingpaper into the cutter opening 2. Otherwise the ap-pliance could be damaged.Switching the appliance into the Auto mode:• Place the switch 1 for shredding into the position"AUTO". The motor starts automatically and swit-ches itself off automatically if no further paper isin-serted. Take note: Always guide smaller papers intothe middle of the cutter opening 2. The contactwhich starts the cutting process is located there.Clearing a material blockage:• Slide the switch 1 into the position "REV"(Re-verse = reverse) should the paper to beshredded jam.The appliance now goes into reverse and thepaper to be shredded is returned.• Pull the paper to be shredded out of the applian-ce and then place the switch 1 at "AUTO".• The appliance is now once again ready for ope-ration.Switching the appliance off:• To switch the device off, slide the switch 1 intothe "OFF" position.• If you do not intend to use the device for a longperiod, disconnect the plug from the mains powersupply.Notice regarding overheating of the appliance:If it overheats, the appliance switches off automati-cally.Attention:Remove the plug from the mains power socket toavoid an unintended starting of the appliance.• Empty the container.• Allow the appliance to cool down.• Re-insert the plug into the mains power socket.• Switch the appliance on, in that the switch 1 isplaced into the position "AUTO".CleaningDanger!Always remove the power plug before cleaning theappliance. There is a risk of receiving an electricshock!Warning!The cutters in the appliance are very sharp! Injuryhazard!Attention:Do not spray oil or any other lubricants into the cut-ter opening 2. These would irreparably damagethe appliance!