Ubiquiti NBE-5AC-Gen2 Quick Start Manual

Also see for NBE-5AC-Gen2: Quick start guide Quick start guide Quick start guide Quick start guide

Contents

19/08/2019 NBE-5AC-Gen2 Quick Start Guidehttps://dl.ubnt.com/qsg/NBE-5AC-Gen2/NBE-5AC-Gen2_EN.html 3/18Main Ethernet PortReset ButtonSecondary Ethernet PortPower LEDMain LEDLAN2 LEDSignal LEDsThis Gigabit Ethernet port is used to connect the power and should be connected tothe LAN and DHCP server.To reset to factory defaults, press and hold the Reset button for more than 10seconds while the device is powered on. Alternatively, the device may be resetremotely via a Reset button located on the bottom of the Gigabit PoE Adapter.This Gigabit Ethernet port provides passthrough PoE to power and connect a 24Vpassive PoE device to the network.Note: In order to use PoE Passthrough on the Secondary port, a 24V, 1APoE adapter is required.The Power LED will light blue when the device is connected to a power source.The LED will light steady blue when an active Ethernet connection is made to theMain port and flash when there is activity.The LED will light steady blue when an active Ethernet connection is made to theLAN2 port and flash when there is activity.In airOS®, you can modify the threshold value for the wireless signal strength LEDson the Wireless tab under Signal LED Thresholds. Each LED will light when theNBE-5AC-Gen2 Quick Start Guide