Ubiquiti NanoBeam ac NBE-5AC-16 Quick Start Manual

Reset Button To reset to factory defaults, press and hold theReset button for more than 10 seconds while the NanoBeamis powered on. Alternatively, the NanoBeam may be resetremotely via a Reset button located on the bottom of theGigabit PoE Adapter.Ethernet Port The Ethernet port is used to connect the powerand should be connected to the LAN and DHCP server. Powercan be provided by any of the following:• Gigabit PoE Adapter (included)• Ubiquiti Networks TOUGHSwitch™ PoE• Ubiquiti Networks EdgeRouter™/EdgeSwitch® PoELEDsPower The Power LED will light blue when thedevice is connected to a power source.Ethernet The Ethernet LED will light steady bluewhen an active Ethernet connection is made andflash when there is activity.Signal In airOS®, you can modify the thresholdvalue for the wireless signal strength LEDs on theWireless tab under Signal LED Thresholds. Each LEDwill light when the wireless signal strength is equalto or greater than the LED’s threshold value. Thedefault threshold values for these LEDs are shownbelow:-94 dBm -80 dBm -73 dBm -65 dBm