46Appendix F: Compliance InformationUniFi™ AP-Outdoor User GuideUbiquiti Networks, Inc.Appendix F: ComplianceInformationInstaller Compliance ResponsibilityDevices must be professionally installed and it is theprofessional installer’s responsibility to make sure thedevice is operated within local country regulatoryrequirements.FCCChanges or modifications not expressly approved by theparty responsible for compliance could void the user’sauthority to operate the equipment.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:1. this device may not cause harmful interference, and2. this device must accept any interference received,including interference that may cause undesiredoperation.NOTE: This equipment has been tested and foundto comply with the limits for a Class A digital device,pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference when the equipment is operated ina commercial environment. This equipment generates,uses, and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructionmanual, may cause harmful interference to radiocommunications. Operations of this equipment in aresidential area is likely to cause harmful interferencein which case the user will be required to correct theinterference at his own expense.Industry CanadaThis Class A digital apparatus complies with CanadianICES-003.To reduce potential radio interference to other users, theantenna type and its gain should be so chosen that theequivalent isotropically radiated power (e.i.r.p.) is not morethan that permitted for successful communication.This device complies with Industry Canada licence-exemptRSS standard(s). Operation is subject to the following twoconditions:1. this device may not cause interference, and2. this device must accept any interference, includinginterference that may cause undesired operation of thedevice.Cet appareil numérique de la classe A est confrome à lanorme NMB-003 Canada.Pour réduire le risque d’interférence aux autresutilisateurs, le type d’antenne et son gain doivent êtrechoisies de façon que la puissance isotrope rayonnéeéquivalente (PIRE) ne dépasse pas ce qui est nécessairepour une communication réussie.Cet appareil est conforme à la norme RSS Industrie Canadaexempts de licence norme(s). Son fonctionnement estsoumis aux deux conditions suivantes:1. cet appareil ne peut pas provoquer d’interférences et2. cet appareil doit accepter toute interférence, y comprisles interférences qui peuvent causer un mauvaisfonctionnement du dispositif.RF Exposure WarningThe transceiver described here emits radio frequencyenergy. Although the power level is low, the concentratedenergy from a directional antenna may pose a healthhazard. Do not allow people to come closer than 20 cm tothe antenna when the transmitter is operating.Additional information on RF exposure is available on theInternet at www.fcc.gov/oet/info/documents/bulletinsL’émetteur-récepteur décrit ici émet de l’énergie defréquence radio. Bien que le niveau de puissance est faible,l’énergie concentrée à partir d’une antenne directionnellepeut présenter un danger pour la santé. Ne pas permettreaux gens de se rapprocher de 20 cm à l’antenne lorsquel’émetteur est en marche.Des renseignements supplémentaires sur l’exposition auxRF est disponible sur Internet àwww.fcc.gov/oet/info documents/bulletinsCE MarkingCE marking on this product represents the product is incompliance with all directives that are applicable to it.Alert sign! Follows CE markingAlert sign must be indicated if a restriction on use appliedto the product and it must follow the CE marking.NB-Identification number (if there is any)Notified body number is indicated if it is involved in theconformity assessment procedure.Please check the CE mark on the product label to find outwhich notified body was involved during assessment.