Ubiquiti UniFi UAP User Manual

Also see for UniFi UAP-Outdoor: User guide User guide

Ubiquiti UniFi UAP User Manual Manual pdf 46 page image

43Chapter 10: User/Guest DetailsUniFi® Controller User GuideUbiquiti Networks, Inc.Chapter 10: User/Guest DetailsThe User and Guest hyperlinks open the User/Guest Detailswindow. Unless otherwise needed to specify differencesbetween the user and guest, this User Guide will refer toboth as user in the rest of this chapter.The upper part of the window has four clickable tabs:• Details (see below)• Statistics (see the next column)• “History” on page 44• “Configuration” on page 44The bottom of the window has two or three buttons:• Block Block this user from accessing the network.• Reconnect Reconnect a user that has been previouslyblocked.• Unauthorize (Available for guests only.) Removeauthorization of wireless guest access and disconnectthe client.DetailsOverviewMAC Address Displays the MAC address of the user.Hostname Displays the name (if defined).IP Address Displays the IP address of the Access Point.Uptime Displays the amount of time the Access Point hasbeen running without interruption.Connected AP Displays the name, alias, or MAC addressof the Access Point in use.If the user is offline, the following information is displayed:MAC Address Displays the MAC address of the user.Hostname Displays the name (if defined).Last Seen Displays the last date and time the user wasconnected to the primary or guest network.StatisticsESSID Displays the network name or SSID of the wirelessnetwork in use.Connected AP Displays the name, alias, or MAC addressof the Access Point in use.Channel Displays the wireless channel in use.Signal Displays the signal strength.TX Rate Displays the TX (transmit) rate.RX Rate Displays the RX (receive) rate.Activity Displays the level of activity in Bytes per second.Power Save Displays the status of the power save mode.Down Pkts / Bytes Displays the amount of datadownloaded by the user in packets and bytes.Up Pkts / Bytes Displays the amount of data uploaded bythe user in packets and bytes.Note: The Statistics tab will only appear when theuser is connected.