Ubiquiti edgerouter X SFP Quick Start Manual

Also see for ER-X-SFP: Quick start guide

Contents

Back PanelPowerGroundResetButton DescriptionResetThere are two methods to reset theEdgeRouter X SFP to factory defaults:Runtime Reset (Recommended)The EdgeRouter X SFP should be running afterbootup is complete. Press and hold the Resetbutton for about 10 seconds until the eth4Link LED starts flashing and then becomessolidly lit. After a few seconds, the LED willturn off, and the EdgeRouter X SFP willautomatically reboot.Power-on Reset1. Disconnect the Power Adapter from theEdgeRouter X SFP.2. Press and hold the Reset button whileconnecting the Power Adapter to theEdgeRouter X SFP. Keep holding the buttonuntil the eth4 Link LED starts flashing andthen stops flashing after a few seconds.Detail DescriptionGroundThe EdgeRouter X SFP is grounded throughthe Power Adapter; however, you can addoptional ESD grounding for enhanced ESDprotection. The ground wire and screw withwasher are not included (recommendedscrew size: M3-0.5 x 4 mm).Power Connect the Power Adapter.