Ultimaker 2+ Installation And User Manual

Also see for 2 Extended: User manual User manual User manual User manual Basic user's guide

Ultimaker 2+ Installation And User Manual Manual pdf 8 page image

8ELECTROMAGNETIC COMPATIBILITY (EMC)This is a class A product. In a domestic environment this product may cause radio interference in which case the usermay be required to take adequate measures.The Ultimaker 2+ can in very rare cases temporarily loose display function caused by ESD. Display function can be fullyrestored by turning the machine off and then on again.The EMC test report of the Ultimaker 2+ is available on request at info@ultimaker.com.ELECTRICAL SAFETYThe Ultimaker 2+ operates on 24 volts (Extra-low-voltage) and is therefore outside the scope of the low-voltagedirective. The power supply meets all CE mark regulations and is protected against short-circuit, overload, overvoltageand overtemperature. For more information concerning electrical safety aspects, please refer to the Mean WellEC-Conformity Declaration for the GS220AX power adapters. Only use the Ultimaker 2+ with power supplies andcables supplied by Ultimaker B.V.MECHANICAL SAFETYThe Ultimaker 2+ contains many moving parts, but the stepper motors do not have enough power to cause seriousinjuries and the moving gears have been covered. Still, it is advised to only reach in the machine when it is turned off.RISK OF BURNSThere is a potential risk of burns, as the print head can reach temperatures of up to 260°C and the heated bed canreach temperatures of up to 120°C. The nozzle of the print head is mostly surrounded by an aluminum cover to preventcontact, but we still advise against reaching into the machine when the print head and/or heated bed are hot.Always let the printer cool down for at least 30 minutes before performing maintenance or modifications.HEALTHThe Ultimaker 2+ is designed to print with PLA and ABS filaments. The use of other materials is at your own risk.When printing with ABS, small concentrations of Styrene vapor can be released. In some cases, this can causeheadaches, fatigue, dizziness, confusion, drowsiness, malaise, difficulty in concentrating, and a feeling of intoxication.Therefore good ventilation is required, and long term exposure should be avoided. It is advisable to use a fume hoodwith active carbon filtering for ductless extraction. Fume extraction is mandatory for use in offices, classrooms, etc.Printing with pure PLA is considered safe, although good ventilation is still advised for possible unknown vaporsreleased from coloring dyes in colored PLA.Only use your printer in a well-ventilated area.HAZARDS