Ultra Start 2250 Series Owner's Manual

Also see for 2250 Series: Installation guide Installation guide

Contents

Being that the installer does not always see when the system shuts down or fails tostart, Diagnostic Memory will store in memory up to four shutdown codes.This information can then be accessed to determine the source of the shutdown.To Enter Diagnostic Mode:Step 1 - Turn the ignition on then off. Press the Program Button and release.Step 2 - The system will respond with three park light flashes and the siren will chirpthe same number of times as the events in memory.(Maximum 4 events, 4 chirps).NOTE: If the siren does not chirp, there are no events in memory.Step 3 - Press the Program Button once to view the last shut down code. The sirenwill chirp once to confirm code one.(If the siren does not chirp, there are no codes in memory.)Step 4 - The LEDs on the antenna will flash a code corresponding to a shut downtrigger. Press the Program Button again to check the second code.The siren will chirp twice to confirm code two.Step 5 - To Clear Diagnostic Memory. While in Diagnostic Mode press and hold theProgram Button for five seconds.The park lights will flash and the siren will chirp once.NOTE: Once diagnostic memory has 4 shutdown events in memory, the system will notRecord any further shutdown events until the system memory has been cleared.Diagnostics/ Diagnostics ChartDIAGNOSTIC MEMORYPark Lights Status LEDs Diagnostic Code3 Flashes Series of 3 Flashes Door Opened “M” Models3 Slow Flashes Solid System is in Service Mode4 Slow Flashes Series of 4 Flashes Not in Reservation Mode “M” units5 Flashes Series of 5 Flashes Hood Pin Opened5 Slow Flashes Series of 5 Flashes Ignition On During Start Attempt6 Flashes Series of 6 Flashes Brake Pedal Shutdown7 Flashes Series of 7 Flashes Tach Lock-OutIf the remote starter does not activate when the start button is pressed the park lightswill flash a diagnostic to indicate what shutdown input has been triggered.Example when the start button is pressed the park lights flash 3 times slowly. Looking atthe chart below this would indicate that the system is in Service Mode.LED Flashes Diagnostic5 Flashes The system was shutdown by the hood pin input6 Flashes The system was shutdown by the brake switch input7 Flashes The system did not detect the tach signal8 Flashes The system made 3 start attempts without startingPage 10OWNER’S GUIDE REMOTE VEHICLE STARTER

/ 12

Related manuals for Ultra Start 2250 Series