2nd Car OperationLock DoorsUnlock DoorsRemote StartingRemote Stop1. Press and release the and buttons at the same time.2. The park lights will flash and the sirenwill chirp once.# LOCKdoors will lock (optional), the3. The LEDs on the antenna will start flashing within five seconds.Note: If installed the starter disable will activate.1. Press and release the and UNLOCK buttons at the same time.2. The doors will unlock (optional), the park lights will flash and the sirenwill chirp two times.3. The LEDs on the antenna will stop flashingNote: If installed the starter disable will deactivate.#1.Press and release the # and buttons.2.The park lights will flash and the siren will chirp once.3.The vehicle will then remote start. The park lights will flash four times thenremain on while the vehicle is running.4. The vehicle will continue to run for the programmed runtime.** (default 15 minutes)1.Press and hold the # and buttons for three seconds.2.The park lights will flash and the siren will chirp two times, theRemote starter will then shut off.Page 11This feature will allow the operation of two Ultra Start remote car starters with one remotetransmitter. This feature requires special programming from the dealer. To control 2nd carfunctions, press the # button at the same time as the command for the second vehicle.Example - Press and release the LOCK button. The 1st vehicle will lock the doors(optional). Press and release (at the same time) the # and LOCK buttons. The 2nd vehiclewill lock the doors(optional).REMOTE VEHICLE STARTER OWNER’S GUIDE