Ultra Start 25XX Series Install Manual

Also see for 25 SERIES: Owner's guide Owner's guide Install guide

Contents

Ultra Start 25XX Series Install Manual Manual pdf 3 page image

Recommended Pre-Installation ProceduresFeature List- Control module - 2 4 button transmitters*- Antenna with built in - 6 pin main harness with dual- Program Button and LED’s 30 amp power inputs.- Multi-tone Siren - 3 pin auxiliary output harness- 14 pin harness - 4 pin Auxiliary sensor harness- 4 pin keyless entry harness - 2 pin Temperature Sensor (LT Models)- Hood pin safety switch - Starter disable harness- Installation and Owner Manuals* The 26xx comes with two 6 button remote transmittersRemote car starters and alarms should be professionally installed.Review the installation and owner manuals and acquire a vehicle wiring diagram for thevehicle to be worked on. Take a few moments to walk around the vehicle looking forany damages and make note if any are found. Also check other functions such asvehicle lighting system, warning lights or check engine lights. Check if the vehicle has afactory security or anti-theft. (Transponder or PASS-LOCK system) These systems willrequire additional parts and labor to complete the installation. Use of the proper toolsand testing equipment is also very important. Never use a grounding style test light totest for wires in the vehicle. Use only a Circuit Safe test light or digital Volt/Ohm Meter.It is the sole responsibility of the installer to test and verify all connectionsNote: This remote starter system is designed for fuel injected and diesel engines.If the vehicle is a manual transmission, a “M” series remote starter must beinstalled. Any model number followed by the letter “M” is specially designed formanual transmission vehicles. The “M” series remote starter will not work in anautomatic transmission vehicle.Components- Auto Tach learning with Quick Learn option - Turbo Timer Mode- Starter Kill/ Anti-Grind Protection - Engine Idle Mode- Remote Panic Feature - System Override Protection- Programmable Wait to Start - Dual Car Operation- Service Mode (Valet) - Park Light Diagnostics- Active/Passive Arming - Program 4 Transmitter Codes- Run Time 4/ 15 or 45 minutes - Ignition Auto Lock- Door Locks .125s/ .75s/3.0s/Double Unlock - Dual Stage Shock Sensor- Cold Start With Four Start Intervals or Temp Mode (LT Models Only)REMOTE VEHICLE STARTER/ALARM INSTALLATION MANUALPage 3