Ultrak KR4008EN Installation Instructions Manual
                                                | |
Contents
| 
10 KRMU000003REV A - 07/20/01BASIC VCR OPERATION AND CONTROLS, continuedRewindinga TapeWhile the tape is stopped, press REW on the front panel or onthe remote control.FastForwardinga TapeWhile the tape is stopped, press FF on the front panel.SpeedSearchwithPictureWhile the tape is playing, press FF for forward speed searchwith picture or press REW for reverse speed search.See further instructions for additional information on searchingtechniques.Pausinga TapeWhile the tape is playing, press PAUSE to freeze the pictureon the screen. (Press PAUSE a second time to return tonormal play.)If you leave the VCR in pause mode for more than 5 minutes,the VCR will automatically stop to prevent damage to the tape.ControllingVibrationduring StillFrameIf the picture vibrates during still frame, press the CHANNELbuttons on the front panel until the picture is steady.UsingRepairedTapesWe recommend that you take any broken or torn tapes to aprofessional for repair. If you repair a torn tape with impropermaterials, you could damage your VCR when you play thetape.USING YOUR REMOTE CONTROLInstallingthe batteries1. To remove the back cover, press the ridged areagently, then push the cover in the direction of thearrow and life.2. Load 2 “AA” batteries, making sure the polarities(+) and (-) are correct. This is marked inside thebattery compartment3. Set the VCR/TV slide switch on the remote control. For use with the KR4008EN (or other)VCR, slide the switch to the VCR setting. For use with a TV, slide the switch to the TVsetting. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine