UniPOS FS5100 Instruction Manual

UniPOS FS5100 Instruction Manual Manual pdf 28 page image

UniPOS Fire Control Panel FS5100Instruction Manual Page 28Revision 7/06.12 Of 47− Flt: Earth – the fire control panel has entered Fault condition: short circuit in ground wire;− Flt: Rst Earth - the fire control panel has exited Fault condition: short circuit in ground wire− Flt: Uintrn – the fire control panel has entered Fault condition: fault in internal supply;− Flt: Rst Uintrn - the fire control panel has exited Fault condition: fault in internal supply;− Flt: Charger – the fire control panel has entered Fault condition: fault in charger;− Flt: Rst Charger - the fire control panel has exited Fault condition: fault in charger ”;− Batt Low – the fire control panel has entered Fault condition: low battery due to interruptedmains supply;− Reset – initial reset of the fire control panel after start up or upon exit of Adjustment Mode;− Manual Adjust – the fire control panel has entered Adjustment mode;− Remote Adjust – the fire control panel has entered Fire Control Panel Parameter or Fire AlarmLine Parameter via interface;− WatchdogReset – the protection timer of the fire control panel is triggered.Press and hold the button to display information screenfor event’s date and time, where HH:MM stand for hours andminutes, DD-MM-YY stand for date, month and year.The screen is visualized when button is being pressed and hold.13.3. Information screen Disabled Controllable OutputsWhere no disabled controllable outputs are available, thefollowing information screen is displayed:Where disabled controllable outputs are available, thefollowing information screen is displayed:The field “12” in screen’s right part contains the numbers of the disabled controllable outputs.13.4. Menu StatusSelect the menu from the screen:The menu contains the following subordinate menus:− Line status− Controllable output status13.4.1. Menu Line statusSelect the menu from the screen:Information screens for the status (current state) of the linesare displayed; N is the number of the selected line, Status is itscurrent state.The following states are feasible:− Normal – for a line in normal state;− Fire 1 – for a line in Fire condition stage I which has not entered fault condition afterwards;− Fire 2 - for a line in Fire condition stage II which has not entered fault condition afterwards;− Disabled – for a disabled line;− Rmvd FD – for a line with removed fire detector;− Intrr – for an interrupted line;− Short – for a line in short circuit.Line N StatusLineStatusDsbl cO 12Dsbl cO НямаHH:MM DD-MM-YY