unigreen 174.12.3 PREMIXER ON HOPPER WITH TIN WASHER (OPTIONAL)Campo 22-32 machines come equipped with the TOP-MIX S-41 premixer(FIG. No. 10); this version of the premixer allows independent adjustment ofpressure knob, avoiding having to change the work settings of the machineevery time you have to do the premixing.To mix the product in the tank proceed as follows:= turn the lever of the delivery deviator to the TOP-MIX position as shown inthe pictogram on the machine.= adjust Top-Mix pressure to approximately 10-12 bar by turning control M(the manometer allows you to check the actual pressure)= press lever 4 for a few seconds introducing 3-4 litres of water into thehopper.= open the premix, overturning the cover as shown in the photo and introdu-ce the product to mix into the hopper 1, close the cover again.= press lever 4 to mix the product in the hopper, watching the level of theliquid which could overflow. To prevent overflowing and to help powderproducts dissolve, open tap 6) to drain into the tank.= after emptying, close tap 6.To wash the tin, proceed as follows:= open the premix, overturning the cover as shown in the photo= supply the premix using the control to regulate a pressure to under 3-4bar= introduce the tin into the hopper, insert washing pipe 2 into the tin, pressthe tin onto the pipe until it has been completely washed.= open tap 6 to drain into the tank at the same time.= after emptying, close tap 6.NB: If the tin washer isn’t supplied with clean water and isn’t fitted with theoptional electrical pump, you must rinse again by hand with clean water.THE LIQUIDS USED FOR RINSING SHOULD BEINTRODUCED INTO THE TANK AND BE SPRAYED ONTHE FIELD.At the end of the operations, wash the hopper:= check that the cover and all the taps of the premix areclosed and open the supply tap on the sprayer, deliveringliquid at a pressure of roughly 10-12 bar (never exceed 15bar).= open safety tap 10.= press lever 4 to activate jets 3 and 9, watching the levelof the liquid which could overflow. To prevent overflowing,open tap 6) to drain into the tank.= after washing, release lever 4 and close taps 6 and 10.NB: At the end of all of the operations put the lever ofthe deviator back into the work position.FIG. N°10Deviator Top MixM11