Unika MT-600Q User Instructions

Contents

page 7OPERATING MODESSTEREO OPERATION : Connect your inputs into channel one and channel two, also channels three and four of the amplifier. Connect your speakers to the outputson the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level (fully counterclockwise). Turn your amplifier on. Turn your input sourcelevel up. Use your front gain controls to regulate the output volume. Be sure not to raise the volume to the clip level, however an intermittent clip signal is acceptable.MONO BRIDGE OPERATION : Be sure your amplifier and all other audio equipment are powered down. Press the Bridge button. Connect input signals to channelone and three. Connect your speaker across the red output binding post on the rear of your amplifier. Turn your equipment on (your amplifier should always be the lastitem you turn on). Apply an input source signal to your amplifier. Use the channel one and channel three gain control to regulate your amplifier output.Important Precautions Introduction Front Panel Rear Panel Set Up Protection SpecificationsOperating ModesUNiKA MT-600QCH 2CH 4CH 1/2STEREOBRIDGECH 1CH 3CH 2CH 4BRIDGE+_BRIDGE+_USE ONLY WITH 250V FUSE____++++ CH 1CH 3/4CH 3BALANCED INPUTSRing=(-)Tip=(+)Sleeve=Gnd_ _+ +4 OhmsMinimumStereoMode8 OhmsMinimumBridgeMode120VAC60Hz1200VAFUSET250V10A LCAUTION: REPLACE WITH SAME TYPE FUSE AND RATINGATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIRWARNING:TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE TO RAIN OR MOISTURECAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENDesigned anddevelopedin the USAManufacturedin TaiwanFigure 9 Typical Stereo Output ConnectionsMT-600QREAR PANELCH-1 InputCH-2 InputSTEREOAMP MODEBRIDGESTEREO FULL RANGE SPEAKERSSPEAKER IMPEDANCE MINIMUM 4 OHMSTEREO FULL RANGE SPEAKERSSPEAKER IMPEDANCE MINIMUM 4 OHMCH-3 InputCH-4 InputFigure 10 Typical Mono Bridge Set-UpCH 2CH 4CH 1/2STEREOBRIDGECH 1CH 3CH 2CH 4BRIDGE+_BRIDGE+_USE ONLY WITH 250V FUSE____++++ CH 1CH 3/4CH 3BALANCED INPUTSRing=(-)Tip=(+)Sleeve=Gnd_ _+ +4 OhmsMinimumStereoMode8 OhmsMinimumBridgeMode120VAC60Hz1200VAFUSET250V10A LCAUTION: REPLACE WITH SAME TYPE FUSE AND RATINGATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIRWARNING:TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE TO RAIN OR MOISTURECAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENDesigned anddevelopedin the USAManufacturedin TaiwanMT-600QREARPANEL CH-1Input OnlyCH-3Input OnlyMONO SUBWOOFER SPEAKERSPEAKER IMPEDANCE MINIMUM 8 OHMMONO SUBWOOFER SPEAKERSPEAKER IMPEDANCE MINIMUM 8 OHMNegative (-) LeadPositive (+) LeadNegative (-) LeadPositive (+) LeadNegative (-) LeadPositive (+) LeadNegative (-) LeadPositive (+) LeadNegative (-) LeadPositive (+) LeadNegative (-) LeadPositive (+) LeadSTEREOAMP MODEBRIDGE