Fuser ReplacementThe fuser is located inside the printer just behind the four image drum units.STEP 1 of 5 STEP 2 of 5Press the cover release and open the printer’s topcover fully.Identify the fuser handle (a). Pull the two fuserretaining levers (b) towards the front of the printer sothat they are fully upright. Remove the new fuserfrom its packaging and remove the transit material.STEP 3 of 5 STEP 4 of 5Holding the new fuser by its handle, make sure that itis the correct way round. The retaining levers (b)should be fully upright, and the two locating lugs (c)should be towards you.Lower the fuser into the printer, locating the twolugs in the slots in the metal partition whichseparates the fuser from the image drums .Pushthe two retaining levers (b) towards the rear of theprinter to lock the fuser in place.STEP 5 of 5Place the drums back into the printer and replacethe lid.WARNING! If the printer has recently been powered on, some fuser components will be very hot. Handle thefuser with extreme care, holding it only by its handle, which will only be mildly warm to touch. A warninglabel clearly indicates the area. If in doubt, switch the printer off and wait at least 10 minutes for the fuser tocool before opening the printer cover.85
