HT580 User Reference Guide Unitech Electronic CO. LTD12.1.2- 2 < SCANNER >Press [2] or [scan] to enter <SCANNER> mode. Press [ESC] to return to the device setting mode.< SCANNER > selection: ON NORMAL/ON FLASH/OFF. Selecting your preference and press [ENTER]to complete the setting.2.1.2- 3 < AUTORUN>Press [3] or [scan] to enter <AUTORUN> mode. Press [ESC] to go return to the device setting mode.<AUTORUN> automatically runs the selected program once you change the default. AUTORUN defaultis set up on <OFF> mode. Three programs can be selected: < FORMCACHING>, <APG580>, and <OFF>.Once you define the selected program, the program will automatically activate when you restart the unit.The main menu will run in the program.2.1.3 < MODEM INIT >To perform modem command, plug in the modem and it will be automatically initiated. To execute <MODEMINIT>, press [3] or [scan] to enter this mode. Press [ESC] to go back to the previous menu.2.1.4 < SUPERVISOR >When entering into <SUPERVISOR> mode, you will be required to input your password.For password and detail reference, please refer to the Technical Binder.Press [4] or [scan] to enter <SUPERVISOR> mode setting. Press [ESC] to go back to the previous menu.2.2 FORMCACHINGIn the main menu, there is FORMCACHING to be performed while scanning.In the default setting for FORMCACHING, you will see “Item” as defined in field 1 and “Qty” as defined infield 2. To change the default of the field, go to “FORM” under “SUPERVISOR” in the mode category. Tostart <FORMCACHING>, press [2] or [scan] to enter and press [ESC] to go back to the previous menu.2.3 RUN APG580To run on “APG580”, please refer to the technical binder for detailed instructions.