Unitech HT630 Product Reference Manual

Also see for HT630: Reference guide User manual Quick start manual Quick start guide Procedures for using

Contents

Unitech HT630 Product Reference Manual Manual pdf 14 page image

HT630 Product Reference GuideChapter 3 OperationThe HT630 is set up several operating modes. The system of terminal may operate in various modes fordifferent purposes. The figure below shows the operating flow of the terminal. The following diagramsummarized these operating modes to switch between different modes.presspresspress and hold downenterprogramthen press pressand keysCMD EXITENTERCMDthen press PWRPWRname(for twopress 2press1seconds)OFFSUPERVISORmode1.SUPERVISOR2.WARM STARTAPPLICATIONmode3.COLD START<>MEM 512KB>HT630 V1.003.COM 4.DIR5.ERA 6.TYP7.CPY 8.SET1.RUN 2.TERRUNcommandUSER modeAlphathenSystem configurations are categorized in two groups, users can select “8.SET” command in User mode toset general system configurations or enter Supervisor mode to set advanced system configurations. TheSupervisor mode is also protected with password checking to prevent unauthorized personnel fromchanging the system configuration.(For HT630 detail setup procedures please refer to HT630 Technical Binder). It is likely that your unitcame pre-configure by your software vender or system developer. In this case, please be caution whenchanging these settings.3.1 Ready ModeThe terminal performs a Power-On-Test and Warm-Start when it is switched on. After the Warm Start, thesystem enters Ready mode and shows the Ready mode prompt.The first line indicates the model code and version number (e.g. V1.00). The secondline shows the size of the total installed RAM (i.e. 4608 KB). The third line prompts a">" which indicates that the terminal passed the Power-on-test and is ready to be used.Ready modepromptHT630 Vx.xxMEM 4608 KB>