Unitech HT630 Reference Manual

Also see for HT630: Product reference guide User manual Quick start manual Quick start guide Procedures for using

Unitech HT630 Reference Manual Manual pdf 21 page image

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.21Ready ModeThe HT630 performs a Power-On-Test and Warm-Start when it is switched on. Afterthe Warm Start, the system enters Ready Mode and shows the Ready Mode Prompt.Ready Mode Prompt The first line indicates the model code and version number (e.g.V1.00). The second line shows the size of the total installed RAM(i.e. 4608 KB). The third line prompts a “>” which indicates that theterminal passed the Power-On-Test and is ready to be used.User Mode and System CommandsThere are eight system commands: RUN, TER, COM, DIR, ERA, TYP, CPY, and SET.Each command can be entered through menu-selection in User Mode. Users canpress the key for two seconds in Ready Mode to enter User Mode.User Mode Prompt Select the corresponding number, 1-8, or press ( )to highlight a command then hit to select a system command.Pressing the key returns to Ready Mode.RUN When you invoke the RUN command, you may press ( )to toggle to the loaded program and hit to run the program.The program may also be executed on the HT630 by entering theprogram name directly in Ready Mode.HT630 Vx.xxMEM 4608KB>1.RUN 2.TER3.COM 4.DIR5.ERA 6.TYP7.CPY 8.SET