Unitech Hand Held Scanner User Manual
                                                        | |
Contents
| 
Page 15Chapter 6 SetupThe scanner interface can be configured to fit the user's specificapplication. All configuration parameters are stored in a non-volatilememory, which is retained even if power is lost.6.1 Bar Code Menu SetupThe setup menu in Appendix D contains eight groups:* Group 1: Device selection.* Group 2: Beep and delay.* Group 3: Keyboard and Wand Emulation.* Group 4: RS-232 Settings* Group 5: Scanner port.* Group 7: Code 39, I 2 of 5, S 2 of 5 and Code 32.* Group 8: Code 128, Code 93, Code 11, Codabar, and MSI.* Group 9: UPC/EAN, and Delta Distance Code.* Group 10: Data Editing.* Group 11: Dump setup.6.1.1 Setup Procedures:For most parameters, proceed the following steps for the setting:1) Locate a group that contains the parameter to be changed.2) Scan the "Enter Group #" label to enter setup mode. The greenLED on the scanner will flash to indicate that setup is in progress.3) Scan the label (on right hand side) representing the parameter to bechanged.(For example, B1 label)4) Scan the labels (number) representing the desired parameter value.(For example, 05, scan “0” and “5” labels.)5) Repeat step 3 and 4, if necessary, to change the parameters in thesame group.6) Scan "Exit" label to end the group setup. The scanner will maketwo beeps to end the setup. |
Related manuals for Unitech Hand Held Scanner
manualsdatabase
Your AI-powered manual search engine