Unitech MS336 Quick Start Manual

Also see for MS336: User manual User manual Specifications Product reference guide

Unitech MS336 Quick Start Manual Manual pdf 1 page image

MS336 2D ImagerQuick Start GuidePlease read before plugging in your scannerHello and thank you for choosing Unitech’s MS336 2D Imager.• To begin using your MS336 Imager, start by installing theUSB driver. The driver can be found on the CD ordownloaded from www.ute.com• Then, install the Imager Configuration Manager. This canalso be found on the CD or our website.• Your next step is to plug your scanner into yourcomputer’s USB port. After a few seconds, your computershould automatically detect the scanner and display amessage that it is ready to use.You may then begin scanning your data or configuring yourMS336. There are two basic modes of operation: HID Emulation,and Imaging Interface.If you use HID Emulation mode, all configurations will have to bedone with the manual, as the ICM software will not recognize thescanner. With this mode, you will be able to scan into anyprogram that you could normally type into, without using theICM software to route output to your programs HID Emulation isthe default mode.The Imaging interface mode is required if you wish to use thesoftware to configure your scanner. In this mode, it is alsorequired to have the software running to scan into any othersoftware including POS and Word processing applications.Enable HID Emulation Mode Enable Imaging Interface Mode

/ 1

Related manuals for Unitech MS336