Unitech MS840B User Manual
Also see for MS840: User manualUser manualQuick reference guideQuick reference guideQuick reference guide
                                                                 | |
Contents
| 
7. After you finish in scanning the pin code, scan the barcode as shown below:CR($M)8. When the pairing is successful, the scanner LED is off and has a short beep.The scanner will operate as HID (keyboard) towards host.Note: When scanning a wrong character, scan the DLE($P) to erase thecharacter(s). After scanning the DLE($P) barcode, please re-scan the pairing pin.DLE($P)Change between Cradle Mode and Cradle-less ModeYou may make the scanner change between cradle mode and cradle-less mode.For example, if your scanner operates currently in cradle-less mode and you wantto change the existing mode of the scanner to cradle mode, then scan the CradleMode barcode as shown below:Cradle ModeTo determine whether your scanner mode is successfully changed, press the Pagebutton on the cradle; your scanner will have 2 short beeps when you press thePage button.For example, if your scanner operates currently in cradle mode and you want tochange the existing mode of the scanner to cradle-less mode, then scan theCradle-less Mode barcode as shown below:Cradle-less ModeWhenever the scanner enters cradle-less mode, you must pair the scanner withyour PC following step 3 through step 8 at the section called “Cradle-less Mode(without SCM Support)”.Note: When you successfully connected in Cradle and/or Crade-less, bothaddresses are memorized in the scanner. To completely disconnect thescanner;1.Scan the Cradle Mode barcode, scan the Delete Address barcode; and2.Scan the Cradle-less Mode barcode, scan the Delete Address barcode.Delete BT AddressDelete Address13 |
Related manuals for Unitech MS840
manualsdatabase
Your AI-powered manual search engine