Unitech MS912 User Manual
Also see for MS912: Quick guideManualManualProgramming guideQuick reference guide
                                                                                                             | |
Contents
| 
- 64 -Codabar CouplingADJACENT REQUIRED. I 033$ . I 034$If CODABAR ADJACENT is enabled, the scanner will only read two adjacent Codabarbar codes; a single bar code will not be read.NOTE: 1. Both ABC-Codabar and CX-Codabar can be enabled together, except whenCodabar-Coupling is also enabled.2. If ABC-Codabar, CX-Codabar, and Codabar-Coupling are all enabled atthe same time, the scanner will read only Codabar- Coupling, that is, ABC-Codabar, CX-Codabar will be considered coupling formats.P023$RESETNOTE: 1. The scanner will beep three times as reminder that a setting is not yetcomplete.2. If you make a mistake, forget a step, etc., scan RESET to start again.CODABAR COUPLING. I 019$ . I 020$ . I 021$. I 041$ . I 026$ABC-Codabar and CX-Codabar have certain rules regarding the Stop Character offirst bar code and the stop character of second bar code while in conjunction, whileCodabar- Coupling is enabled, the data from any two Codabar bar codes can becoupled into one set of data without any limitationsbetween the Stop character of first bar code and the Start character of second barcode. The Start and Stop characters associated with each bar code will be sent.* The data can be any alphanumerics of FULL ASCII Table (page 75-86)SETTING PROCEDURE - SET INSERT DATASTEP 1 - Scan SET INSERT DATA.STEP 2 - Scan any combination of alphanumeric characters from FULL ASCII Table.STEP 3 - Scan SET INSERT DATA. |
Related manuals for Unitech MS912
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine