Unitech MS920 User Manual
Also see for MS920: User manualUser manualQuick start guideQuick start guideUser manual
                                                                                                                       | |
Contents
| 
- 82 -Turn off after good read- When active, the scan engine stops the reading session after a successfuldecoding.- Turn off after good read is only used in the following trigger modes:- Level- Pulse- Autostand- Standard AimNOTE: this parameter is NOT used with contiEnable (*)DisableRetrigger delay- Only valid if "Turn off after good read" is disabled.- This setting is a time delay in which the scanner turns off after a good read.When the delay is done, the scanner automatically turns back on (retriggers).- Value is in milliseconds.0 (*)Compose: Please refer to SCM (Software Configuration Manager) in www.ute.comAimer mode- Allows you to locate the bar code you want to read.- The aiming beam is only used with the following trigger modes:- Level |
Related manuals for Unitech MS920
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine