Important - please readGeneral installation2 7Maintenanceflow straighteneraerator (fitted)The mixer is supplied with an aeratorfitted as standard. To improve the flowrate in low pressure conditions thisaerator can be changed for the plasticflow straightener provided. Carefullyunscrew the mixer nozzle taking greatcare not to damage the plated finish.Please read these instructions carefully before starting installation and keep for futurereference.Remove all packaging and check the product for missing parts or damage beforestarting installation.Any alterations made to this product and fittings may infringe water regulations andwill invalidate the guarantee.The installation must comply with all Local/National Water Supply AuthorityRegulations/Byelaws and Building and Plumbing (UK:BS6700) Regulations.We strongly recommend that you use a qualified and registered plumber.These fittings are mixing devices and therefore water supplies must be reasonablybalanced.Where connections are made to the mains cold water supply, WRC approved singlecheck valves must be fitted to both hot and cold inlets. This is a stated requirement ofWater Supply (Water Fittings) Regulations 1999 Schedule 2, Section 6 G15.13.2Before making any inlet pipe connections, all supply pipes MUST be thoroughlyflushed to remove debris. Failure to do so could result in damage or low flow from themixer unit. Water Supply (Water Fittings) Regulations 1999 Schedule 2 Section 4 G13.1The fitting of isolating valves to the inlet feeds is advised for ease of maintenance.Please take great care when installing this mixer not to damage its surface.Please note if installing in an enclosed environment, access should be left for servicingand maintenance. No costs relating to inadequate access can be accepted.Care of the mixerOur products are finished to the highest standard and due care needs to be taken toensure their looks are retained.We recommend cleaning all products with a soft damp cloth ONLY and advise stronglyagainst the use of ALL cleaning products i.e. powders and liquids.If the above instructions are not followed this will invalidate your guarantee in theevent of a problem occurring.