Vacon 100 x Installation And Maintenance Manual

Also see for 100X series: Installation manual User manual User manual Technical guide User manual

Contents

Vacon 100 x Installation And Maintenance Manual Manual pdf 85 page image

Options vacon • 82Service support: find your nearest Vacon service center at www.vacon.com88.2.5 VACON® keypad with graphical displayThe graphical keypad features an LCD display and 9 buttons.8.2.5.1 Keypad displayThe keypad display indicates the status of the motor and the drive and any irregularities in motor ordrive functions. On the display, the user sees information about his present location in the menustructure and the item displayed.8.2.5.2 Main menuThe data on the control keypad are arranged in menus and submenus. Use the Up and Down arrowsto move between the menus. Enter the group/item by pressing the OK button and return to the for-mer level by pressing the Back/Reset button.The Location field indicates your current location. The Status field gives information about thepresent status of the drive. See Figure 60.Figure 60. Main menu.8.2.5.3 Using the graphical keypadEditing valuesThe selectable values can be accessed and edited in two different ways on the graphical keypad.Parameters with one valid valueTypically, one parameter is set one value. The value is selected either from a list of values (see ex-ample below) or the parameter is given a numerical value from a defined range (e.g. 0.00...50.00Hz).Change value of a parameter following the procedure below:1. Locate the parameter.2. Enter the Edit mode.3. Set new value with the arrow buttons up/down. You can also move from digit to digit with thearrow buttons left/right if the value is numerical and then change the value with the arrow but-tons up/down.4. Confirm change with OK button or ignore change by returning to previous level with Back/Reset button.Location fieldStatus field(Parameter ID numberMain MenuQuick Setup( 17 )Parameters( 12 )STOP READY I/OID: M1( 5 )Monitor Activated group/item. Press OK to enter.Number of items in the groupSTOP/RUNStatus fieldREADY/NOT READY/FAULTControl place:PC/IO/KEYPAD/FIELDBUSALARMand current menu location)Direction