Vacon 100 x Installation, Technical And Maintenance Manual

Also see for 100X series: Installation manual User manual User manual Technical guide User manual

Contents

Vacon 100 x Installation, Technical And Maintenance Manual Manual pdf 108 page image

8vacon • 106 OptionsLocal contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/8.4 Option boardsVACON® 100 X drive family embodies a wide selection of expander boards with which the availableI/O of VACON® 100 X AC drive can be increased and its versatility improved.There are two board slots (labelled D and E) on the VACON® 100 X control board. To locate the slot,see chapter 5. Usually, when the AC drive is delivered from the factory, the control unit does notinclude any option board in the board slots.The following option boards are supported:See the Option boards User’s Manual to use and install the option boards.Table 40. Option boards supported in VACON® 100 X.Code Description NoteOPTB1 Option board with six bidirec-tional terminals.With jumper blocks it is possible touse each terminal as digital input oras digital output.OPTB2I/O expander board with athermistor input and two relayoutputs.OPTB4I/O expander board with onegalvanically isolated analogueinput and twogalvanically isolated analogueoutputs (standard signals0(4)…20mA).OPTB5 I/O expander board with threerelay outputsOPTB9I/O expander board with five42…240 VAC digital inputs andone relay output.OPTBFI/O expander board with ana-logue output, digital output andrelay output.On the OPTBF board, there is onejumper block for selecting the ana-logue output mode (mA/V).OPTBHTemperature measurementboard with three individualchannels.Supported sensors: PT100, PT1000,NI1000, KTY84-130, KTY84-150,KTY84-131OPTBK AS-interface option boardOPTC4 Lonworks option board Pluggable connector with screw ter-minalsOPTE3 Profibus DP option board Pluggable connector with screw ter-minalsOPTE5 Profibus DP option board 9-pin Sub-D terminalOPTE6 CANopen option boardOPTE7 DeviceNet option board