Vacon 20 SERIES Applications Manual

Also see for 20 SERIES: Quick guide

Contents

Vacon 20 SERIES Applications Manual Manual pdf 17 page image

Description of Groups vacon • 14Service support: find your nearest Vacon service center at www.vacon.com22.2 Parameter Groups: Menu PARThe Decentralized Application embodies the following parameter groups:Table 29: Parameter groupsColumn explanations:Code = Location indication on the keypad; Shows the operator the parameter num-ber.Parameter= Name of parameterMin = Minimum value of parameterMax = Maximum value of parameterUnit = Unit of parameter value; Given if availableDefault = Value preset by factoryID = ID number of the parameterDescription= Short description of parameter values or its function= The parameter may be changed only in Stop stateMenu and Parameter group DescriptionGroup Motor settings: Menu PAR G1 Motor settingsGroup Start/Stop Settings: Menu PAR G2 Start/Stop and mode settingsGroup References: Menu PAR G3 Frequency reference selectionGroup Ramps: Menu PAR G4 Ramp timesGroup Input functions: Menu PAR G5 Digital input programmingGroup Output functions: Menu PAR G6 ASi and digital output programmingGroup Mechanical brake: Menu PAR G7 Mechanical brake programmingGroup Supervisions: Menu PAR G8 Supervision programmingGroup Motor Control: Menu PAR G9 Motor control and U/f parametersGroup Protections: Menu PAR G10 Protections configurationGroup Automatic reset: Menu PAR G11 Auto reset after fault configurationGroup Non-ASi fieldbus: Menu PAR G12 Non-ASi Fieldbus data out parametersGroup Analogue output: Menu Par G13 Analogue output programmingGroup User interface: Menu Par G14 User interface parameters