Vaillant ecoTEC plus 937 Operating Manual

Also see for ecoTEC plus 937: Instructions for installation and servicing Operating manual Instructions and maintenance instructions

Contents

Vaillant ecoTEC plus 937 Operating Manual Manual pdf 8 page image

Operating instructions ecoTEC plus 93784.2 Measures prior to commissioning4.2.1 Opening the isolating valvesh NoteIf the boiler is fitted with a bottom cover theisolating valves are under this cover.90˚4312Fig 4.3 Opening the isolating valves• The stop cocks in the heating flow and return (2 and4) and the gas stop-cock (1) must be open. These stop-cocks are open if the slot for the screwdriver isparallel to the piping run.• The cold water stop cock (2) must be open. In order tocheck this you can open a hot water tap at a draw-offpoint and see if water flows out.4.2.2 Checking system pressurebari F Pbar1Fig. 4.4 Checking the filling pressure of the heating system• Check the filling pressure of the system using thepressure gauge (1) before putting it into operation.For the heating system to operate properly, the indicatoron the pressure gauge must be in the dark grey zonewhen the system is cold. This corresponds to a fillingpressure between 1.0 and 2.0 bar. If the indicator is inthe light grey area (below 0.8 bar), fill the system upwith water before putting it into operation.h Note!The ecoTEC appliances come with a manometerand a digital pressure indicator.The manometer allows you to quickly checkwhether the filling pressure is in target range ornot even when the appliance is turned off. Whenthe unit is in operation, you can have the exactpressure shown in the display. Activate thepressure display by pressing the "-” button (2).After 3 seconds the display returns to the feedtemperature.Note:Note: To avoid running the system with toolittle water and thus prevent damage, yourappliance has a pressure sensor. This signalsthe low pressure level if the level falls below0.6 bar by the water pressure value in thedisplay flashing.If the pressure falls below 0.3 bar the unitswitches off. The error message F.22 appears inthe display. Fill the system up with water beforeyou start up the appliance again.If the heating system extends over several storeys, thesystem may require a higher filling pressure. Ask yourengineer for details.4 Operation