Chapter 5 __________________________________________ Software Configuration and OperationVAISALA ______________________________________________________________________ 111Software Configuration ProcedureCAUTION Configure AWS330 by following this procedure step by step.NOTE Navigating in the screens is explained in section General Instructions onUsing AWS Client on page 104. Read it carefully.1. Set Common Parameters as described on page 112.2. Set Location Parameters as described on page 113 (optional).3. Set time as described in section Time and Time Zone on page 114.4. Set Sensor Parameters as described on page 116.5. Select the message type you want to use with AWS330. Formessage type descriptions, see section Observation Messages onpage 27.6. Set message transmission interval for the selected message type asdescribed in section Message Intervals on page 118.7. Select observation messaging protocols(s) as described in sectionMessaging Protocols on page 119.8. Select alarm messaging protocol(s) as described in sectionAlarming Protocols on page 121.9. Set messaging protocol -dependent parameters. Based on theprotocol(s) chosen in steps 7 and 8, refer to following section(s):- TCP-Socket (Virtual Com Port) on page 122.- File Transfer Protocol (FTP) on page 124.- eMail (SMTP) on page 126.- GSM SMS on page 129.- Local Serial Line on page 130.- For CSD dial-in, there is no protocol-dependent configurationrequired.10. Set up telemetry configuration:- For IP over GPRS telemetry, see section GSM Modem on page131 and GPRS on page 132.- For data call telemetry, see section GSM Modem on page 131and CSD Dial-In (Data Call) on page 134.- For IP over Ethernet telemetry, see section Ethernet on page135.11. Set up alarm limits as described in Alarms on page 136.12. To make parameter updates effective, reset the AWS330 systemusing AWS Client. From the AWS Client menu, selectMaintenance - Reset - Immediate.
