Vallox DIGIT SE Instructions For Use And Maintenance Manual

Contents

Vallox DIGIT SE Instructions For Use And Maintenance Manual Manual pdf 9 page image

VALLOX DIGIT SE/SE VKL9INSTRUCTIONS FOR USING THE CONTROL PANEL© VALLOX • We reserve the right to make changes without prior notification.3.3. Settings menuYou can reach the settings menu from the operating menu as indicated in section 3.2.2. The displays of the settings menu(sections 3.3.1.–3.3.26.) can be scrolled with the scrolling buttons (see section 3.1., items 5 and 6 in the figure).3.3.1. Setting the basic fan speedThe desired basic fan speed (minimum fan speed) is selected with the + and – buttons. Active whenweek clock control is not on. Week clock control changes this speed.MIN speed13.3.2. Moving to the operating menuYou can return to the operating menu by pressing the + and – buttons simultaneously.To main menuPress + and -The maximum fan speed setting can be selected to be active either in connection with (carbon dioxideand humidity) adjustments or permanently. The selection is done with the + and – buttons.3.3.6. Mode of operation of the maximum speed settingMAX Speed limitwith adjustmentsSelect the desired language (German, English, Swedish, French or Finnish) with the + and – buttons.3.3.7. Choosing the language versionKieli / LanguageEnglishThe general factory settings can be restored by pressing the + and – buttons simultaneously.Remember to ensure that the setpoints are in accordance with the factory settings for this unit.Especially, check the unit model (electricity / water) and change if needed as stated in section3.3.20.3.3.8. Restoring factory settingsFactory settingssee manualThe adjustment interval for humidity and carbon dioxide adjustments is selected with the + and –buttons. The adjustment interval refers to minutes.3.3.9. Adjustment intervalAdjust interval10The maintenance reminder is reset by pressing the + and – buttons simultaneously. Thisturns out the maintenance reminder symbol ( ) in the main display.3.3.10. Resetting the service reminderMainten. resetPress + and -The contrast setting for the control panel display is changed with the + and – buttons.3.3.11. Contrast of the control panel displayDisplay contrast05The week programme can be totally erased by simultaneously pressing the + and – buttons.3.3.3. Erasing the week programmeErase week prog.Press + and -You can access the programming mode for the week clock programme by simultaneously pressingthe + and – buttons. See section 3.4.1.3.3.4. Week programme programmingAdjust week prog.Press + and -You can adjust time by simultaneously pressing the + and – buttons. For more details, see section3.4.2.3.3.5. Adjusting timeAdjust timePress + and -The address of the control panel is changed with the + and – buttons. Two control panels cannothave the same address. If control panels have the same address, they will go to the bus fault stateand will not operate.3.3.12. Address of the control panelPanel address1The desired adjustment value for the DC fan is selected with the + and – buttons. The rotation speedof the extract air fan can be lowered by decreasing the percentage value. If the unit has alternatingcurrent fans, this adjustment has no impact on the operation of the unit.3.3.13. Adjusting the direct current fan on the extract air side (does notrefer VALLOX DIGIT SE)DC fan exhaust100%