VANNER Incorporated Owner’s ManualLifeStar Owner’s Manual - 9 -Inverter Lamp DescriptionInverter Light Action DescriptionSteady Green Light Inverter in On and Operating.Single Blink Green Light Inverter circuit is in Stand-by, Shore power is On and supplying AC power to theAC loads. The Inverter will turn On and supply the load if shore power is lost.Double Blink Green Light Inverter circuit is in load Demand. Shore power is Off. The inverter is waiting for aload greater than 20 watts.Battery Low Light Action DescriptionSolid Red Inverter is On and the battery is almost too low to operate the inverter.Blinking Red The inverter is Off. The battery voltage dropped below 10.5 volts DC and theinverter shut itself Off. The inverter On/Off switch must be cycled to reset the unit.Overtemp Light Action DescriptionSolid RedThe unit is Off. The unit has turned itself Off because it is too hot. This can becaused by operating an AC load which is too large for the inverter, or lack ofventilation. When the unit cools the inverter will start operating again.Overload Light Action DescriptionBlinking Red The inverter is On but overloaded. Reduce the AC load quickly or the inverter willshut off due to the overload condition.Solid RedThe inverter is Off. An overload has occurred and the inverter has shut off toprotect itself. Reduce the AC load, the inverter On/Off switch must be cycled toreset the unit.ChargerBulk Absorption Light Action DescriptionBlinking YellowThe charger is operating. The batteries were low and in need of a charge. Thecharger is in the process of charging the batteries to the bulk voltage. Thecharging current is limited based on the position of the Charger High/Low switch.ChargerReady/Maint. Light Action DescriptionSolid GreenThe charger is operating. The batteries are near full charge and the charger is inthe maintenance mode. In this stage, the charger is holding the batteries at thefloat voltage. The charging current is limited based on the position of the ChargerHigh/Low switch.