Vatech PaX-i3D User Manual

Also see for PaX-i3D Smart: User manual Installation manual

Contents

Vatech PaX-i3D User Manual Manual pdf 115 page image

PaX-i3D Green (PHT-60CFO) User Manual1158 Acquiring CT ImagesI. Click CONFIRM to accept these parameters.NOTEPlease wait for a moment, while the rotating unit moves toits initial scanning position.When you click CONFIRM button:■ The CONFIRM button turns to the SCOUTand then the READY button is enabled andflashes. This means that the equipment isready for X-ray exposure.NOTESCOUT capture is featured in FOV size 50 X 50 and 80 X50. In case of abnormal patient’s arch, the chinrest heightadjustment through the SCOUT feature enables the userto acquire better image. When the SCOUT image needs tobe acquired, position the patient first, followed by clickingthe SCOUT button. For details about imaging in the SCOUTmode, refer to the section “8.3 Acquiring a Scout image”.■ The Rotating unit will move to its initial scanning position.■ The Chinrest will adjust itself according to the mode selected.■ Three laser beams (CT horizontal (X), Mid-sagittal (Y) and CT vertical (Z))will activate to facilitate patient alignment. These beams will disappear after20 minutes or if the READY button is clicked.NOTELaser beam On / Off buttons: Imaging Program: Control Panel■ The scan time and DAP (Dose AreaProduct) value are shown on the maindisplay for the intended exposure.J. Guide the patient to the equipment. Position the patient. Refer to section 8.2Positioning the Patient.