148 LightingDoor-to-door light function3Dipped beam and reverse lights 3illuminate for around 30 seconds after thedriver exits the vehicle and closes his door.To activate1. Switch off ignition.2. Remove ignition key 3.3. Open driver’s door.4. Pull turn signal stalk toward steeringwheel.5. Close driver’s door.If the driver’s door is left open, the lights willgo out after two minutes.The light is switched off immediately byinserting the key into the ignition or pullingthe turn signal stalk again with the driver’sdoor open.Instrument illumination ,information display illuminationComes on when ignition is switched on.Brightness can be adjusted when theexterior lights are on: Push to releaseknob k and then turn it clockwise oranti-clockwise and hold until the desiredbrightness is obtained.Display mode 3, see page 134.Courtesy lightAutomatic interior lightComes on automatically when the vehicle isunlocked with the remote control, when adoor is opened or when the key is removedfrom the starter switch after the ignition isswitched off.Goes off automatically after a delay whenthe doors are closed or immediately whenthe ignition is switched on or the doors arelocked.Front courtesy lightTo operate manually from inside when thedoors are closed:On = Press button cOff = Press button c again
