2SAFETY INFORMATIONSave these instructionsBe sure to read and understand all WARNINGS and CAUTIONS before using this product. Pleaseread this guide carefully before use to ensure optimum performance and avoid damage to thesystem or items that you are using it with.WARNINGS: WARNING STATEMENTS IDENTIFY CONDITIONS OR PRACTICESTHAT MAY RESULT IN PERSONAL INJURY OR LOSS OF LIFE.1) When working with lead acid batteries, always make sure immediate assistance isavailable in case of accident or emergency.2) Always use protective clothing and eyewear when using this product, contact with batteryacid may cause blindness and/or severe burns. Be aware of first aid procedures in caseof accidental contact with battery acid.3) There is a risk of explosive gases being released when lead acid batteries are beingcharged or discharged. Failure to follow instructions may cause property damage,explosive hazard, and/or personal injury.4) Make sure the safety switch is off before connecting battery clamps to discharged battery.5) When charging unit from a 110/120 volt AC electrical outlet, in any wet or damp area,make sure that the outlet used is protected by a ground fault interrupt (GFCI) outlet.6) When charging the unit near water, do not allow the electrical cords and outlets toget wet; electrical shock could result.7) Jump-start procedures should only be performed in a safe, dry, well-ventilated area.8) Always store battery clamps in built-in holsters when not in use. Never touch batteryclamps together - this can cause dangerous sparks, power arcing, and/or explosion.9 When using this unit in proximity to the vehicle’s battery and engine, stand the unit on aflat, stable surface, and be sure to keep all clamps, cords, clothing, and body parts awayfrom moving veh icle components.10) Do not wear vinyl clothing when jump-starting a vehicle-friction can cause dangerousstatic electricity sparks. Remove all jewelry or metal objects that could cause short circuitsor react with battery acid.11 Always disconnect the negative (Black) jumper cable first: followed by the positive (Red)jumper cable.12) Never allow red and black clamps to touch each other or another common metalconductor - this could cause damage to the unit and/or create sparking/explosionhazard. Always store battery clamps in built-in holsters when not in use.13) Do not expose battery to fire or intense heat as it may explode. Before disposing of thebattery, protect exposed terminals with heavy-duty electrical tape to prevent shorting(shorting can result in injury or fire).14) Do not smoke, use matches or cigarette lighters while working on a veh icle’s batterysystem.17) Keep unit out of reach of children (whether stored, or in use)!Vec010S manual 03/04 5/22/06 11:19 AM Page 2