5VEEDER-ROOTPGM RSTOP1OP2VEEDER-ROOTPGM RSTOP1OP2VEEDER-ROOTPGM RSTOP1OP2VEEDER-ROOTPGM RSTOP1OP2VEEDER-ROOTPGM RSTOP1OP2VEEDER-ROOTPGM RSTOP1OP2VEEDER-ROOTPGM RSTOP1OP2O P E R A T I O NOPERATION MODECHANGING A PARAMETER VALUEPGMPGMPGMDefault display is the present timevalue.Pressing the Program Key will cause thedisplay description to appear on themain display.* If there is no key activityfor 3 seconds, the primary display willswitch back to the count value.Continued pressing of the Program Keywill scroll to the Set value. (SeeParameter Sequence below.) The fullparameter description will appear on themain display.*To change the Set value, press the ScrollKey. If there was no key activity for 3seconds, the Set value will appear (onedigit description shown on secondarydisplay); however, press the Scroll Keyin order to edit. The unit will now be inEdit Operation as signified by the mostsignificant digit flashing.**Use the Scroll Key to move from left toright and highlight the digit that needsto be changed. Wrap around will occurfrom the least significant to the mostsignificant digit.Use the Down Key to decrement thedigit until the desired value appears.The display will wrap around from 0 to9.After the desired digits have beenchanged, press the Program Key to enterthe new value. The new value willappear on the main display without anyflashing digits. Press the Progam Keyagain and the parameter description willappear on the main display.23456SEtti<>ES34567S34567S33567SEtPGM* Parameter descriptions will notappear on the primary display if the"Help" function has been disabled.** Edit Operation cannot beaccessed if the Preset Lock hasbeen enabled in Program Mode.PARAMETER SEQUENCEt i < > E Time ValueFunction: Displays present time valueRange: 0 to 99999PGMSet ValueFunction: Defines the value at whichOutput 1 will be activatedAdjustment Range: 0 to 99999Default Value: 0S E t Swww.TheTimerAndCounterCompany.com