Veeder-Root TLS-350R Installation Manual

Also see for TLS-350R: Installation manual Install, Setup, & Operation Manual Installation guide Installation guide Application guide

Veeder-Root TLS-350R Installation Manual Manual pdf 6 page image

Installation Guide Contractor Certification Requirements1IntroductionThis manual describes site preparation and installation procedures for the Veeder-Root TLS RF WirelessSystem. This system is designed for standard tank monitoring and leak detection* applications in which in-ground probe wiring is either impractical or non-existent.Procedures contained within this manual include:• Mounting the TLS RF Wireless Interface Unit (TLS RF) and connecting power wiring.• Installing TLS RF Wireless System’s receiver, transmitter, and repeater components throughout thesite.• Connecting the TLS RF to the TLS console.Other required devices, such as the TLS console and necessary magnetostrictive (mag) probes/mag sumpsensors, are to be installed following instructions shipped with those devices.After installing the TLS RF Wireless System, you must configure the probes and sensors in the TLS consolefollowing instructions contained in the console’s System Setup Manual.*Certified SLD (Static) & CSLD (Continuous) Leak Detection for single tanks and Mag Sump Sensor monitoring, where ambientinterference is not a factor.Component CompatibilityThe Veeder-Root Form Number/Part Number TLS RF Wireless System compatible components are asfollows:• 8466 TLS-IB console• 8469 TLS-50 console• 8470 TLS-350 console• 8482 TLS-350R console• 8485 TLS-300 console• 8560 TLS2 console332235-011 Transmitter with 332425-011 Battery Pack will monitor probe/sensor form numbers listedbelow:• 8462, 8463 and 8563 Mag Plus Probe• 8468 Global Mag Probe• 8570 Mag Sump Sensor