Vega VEGACAP 62 Operating Instructions Manual

Also see for vegacap 62: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

6 Set up6.1 General informationThe figures in brackets refer to the following illustrations.On the electronics module you will find the following indicating andadjustment elements:l DIL switch for measuring range selectionl Control lampNote:As a rule, always set the mode with the mode switch of the signalconditioning instrument before starting setup VEGACAP 62. Theswitching output will change if you set the mode switch afterwards.This could possibly trigger other connected instruments or devices.6.2 Adjustment elements4123Fig. 13: Electronics module - Two-wire output1 DIL switch for measuring range selection (with compensation button)2 Ground terminal3 Connection terminals4 Control lampA failure can be displayed with closed housing (only plastic housing),see operating instructions manual of the "Signal conditioning instru-ment".Note:Screw the housing cover tightly up to the thread stop so that theinspection glass is above the control lamp (LED).Function/ConfigurationVEGACAP 62 • - two-wire 216 Set up30007-EN-090604